Click on the image above to learn more about the M1 Carbine
|
Rear Sight Windage Setting |
Post Reply |
Author | |
jackp1028
Hard Corps Joined: Jan 01 2016 Location: Cloudcroft, NM Status: Offline Points: 1273 |
Post Options
Thanks(0)
Posted: Dec 29 2017 at 4:46pm |
Does anyone know why most carbine rear sight windage adjustments have to be set to the left of the rifle's centerline in order to zero. All of my carbines are set at least 1/16" and some as much as 1/8" left of the centerline of the receiver? Others have made the same comment but so far I haven't seen an explanation. Not really a problem, but is this a design artifact or an accumulation of tolerances or a result of the manufacturing process? Just curious.
|
|
JackP
|
|
Charles
Grunt Joined: Mar 21 2016 Location: Maryland Status: Offline Points: 587 |
Post Options
Thanks(0)
|
JackP
After reading your post, I removed the stock from my Saginaw S'G' and placed a straight edge along the sides of the receiver. The difference at the muzzle (just behind the barrel band slid up to the sight) was .1615 on the left side and .2420 on the right side. If I'm not mistaken this would necessitate moving the site to the left. What do you think? Charlie |
|
Charles
Co B 1st Batl.115 Inf. Reg. 29th. Divi. 4.2 Heavy Mortar Co Retired Life member NRA |
|
jackp1028
Hard Corps Joined: Jan 01 2016 Location: Cloudcroft, NM Status: Offline Points: 1273 |
Post Options
Thanks(0)
|
On my Inland, which is offset the most (1/8"), I measured .170 on the left and .200 on the right. However, I was only able to take my measurements mid-barrel because it has a Type 3 barrel band. If the barrel is straight, the .030 difference would not account for the nearly (correction) .125 offset. Perhaps the barrel is bent, but more likely it is canted to the left due to the barrel and receiver mating surfaces not being perfectly square. Also, although the left and right side of the receiver may look equal distant from the center-line of the barrel, they may actually be different. The right side has sliding parts that have to fit properly and was probably held to tighter tolerances. The left side doesn't matter . It just has to fit into the stock. It would help if there was an original dimensioned drawing available that we could check. I suspect that there is some misalignment that is a combination of things, to include receiver and barrel square, barrel straightness and tolerance stack.
By the way, there is probably some similar built in vertical variation, but we don't notice it so much because nothing looks "wrong". We just fix it by filing the front sight. |
|
JackP
|
|
Charles
Grunt Joined: Mar 21 2016 Location: Maryland Status: Offline Points: 587 |
Post Options
Thanks(0)
|
This brings to mine, when I had a gun smith switch my flip sight to an adjustable he said it looks as tho the base of the sight is not centered because something wasn't even. It was too far to the right and I had to adjust the windage almost tight against the left side. I didn't like that so I hammered the base more to the left and after zeroing in at the range the graduations are nearly lined up.
|
|
Charles
Co B 1st Batl.115 Inf. Reg. 29th. Divi. 4.2 Heavy Mortar Co Retired Life member NRA |
|
Post Reply | |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You can vote in polls in this forum |